| Breadboard Design 
|
The original breadboard design that
featured V1 software. This unit was used for mobile testing most weekends on the passenger
seat! |
| Finished EYTraker Unit V2.00 PCB
View 
|
The V2 PCB partially completed. TheV3 PCB
has replaced most design features on this photo. |
| Finished EYTraker Unit V2.00 Front
View 
|
The V2 EYTraker boxed up. This unit served
as the software testing unit in my car for six months.It is still installed in ZS6EY-14
but has since had the V3 PCB and software upgrade. This unit has clocked more than 15 000
km in my VW Touran! The V3 looks the same but has many more features. |
| Finished EYTraker Unit V2.00 GPS
Module View 
|
This V2 PCB view shows the GPS integration
into the PCB. Heatsink at the back of the Unit. |
| The next step: VeroBoard Magic 
|
The next step in the design process was to
move from Breadboard to Vero Board, you can say from bad to worse...this picture shows PCB
V2 made smaller for vehicle testing. |
| The V2.00 PCB 
|
The EYTraker comes with a high quality PCB.
PCB V2.00 show in the photo. |
| Typical Installation with Kenwood
TM D700 (I) 
|
This is a typical installation in a VW
Touran. The NMEA string from the EYTraker is fed to the Kenwood TM D700 which serves as a
GPS input. |
| Typical Installation with Kenwood
TM D700 (II) 
|
This is a typical installation in a VW
Golf. The NMEA string from the EYTraker is fed to the Kenwood TM D700 which serves as a
GPS input. Note the short quadband rubberduck antenna. |
| The uBlox RCB-LJ GPS Module 
|
This is the GPS module that is used in the
EYTraker unit. |
| The V3 EYTraker PCB 
|
This is the new V3 EYTraker PCB manuctured
by Bosco PCB in Edenvale. |
| The V3 EYTraker PCB with Resistors
installed. 
|
The PCB with the resistors and LT1528
installed. |
| EYTraker complete with GM862-GPS 
|
The completed PCB showing GM862-GPS instead
of the uBlox GPS unit. |
| EYTraker complete with GM862-GPS
side view 
|
The completed PCB showing GM862-GPS instead
of the uBlox GPS unit. |
